TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-103
Message Descriptions
340
Cause. The command attempted to configure an auxiliary audit trail with the
AUDITDUMP option set to ON, but the master audit trail has this option set to OFF. If
any auxiliary audit trail is to be dumped, the master audit trail must be dumped.
Effect. The command fails.
Recovery. Reset the AUDITDUMP option to ON for the master audit trail, and then re-
enter the command. Or, re-enter the command with the AUDITDUMP option for the
auxiliary audit trail set to OFF.
341
volume
is the name of the volume specified in the command.
Cause. The command specified too many files per volume for an audit trail. The
FILESPERVOLUME parameter specifies the number of files in the audit trail that
reside on each active-audit volume configured. For this parameter, the minimum
number is 1 and the maximum is 100.
Effect. The command fails
Recovery. Re-enter the command, specifying a value from 5 through 100 for the
FILESPERVOLUME parameter.
342
Cause. The command attempted to modify the TMF configuration, but the
configuration must be totally removed from the system for this command to be
executed.
Effect. The command fails.
Recovery. If you are ready to delete the TMF configuration, do so (or ask your system
manager to do so). Then, re-enter the command.
An auxiliary audit trail cannot be configured with AUDITDUMP
ON unless the master audit trail is also configured with
AUDITDUMP ON.
The number of active audit trail files on volume volume
cannot be adjusted to the specified FILESPERVOLUME parameter.
Before issuing this command, you must first delete the
current TMF configuration.