TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-108
Message Descriptions
355
Cause. An ADD AUDITTRAIL command attempted to add an audit trail after a new
TMF configuration had been generated. New audit trails, however, can only be added
after the DELETE TMF command purges the old configuration but before the START
TMF command generates the new one.
Effect. The command fails.
Recovery. See your system manager.
356
volume
is the name of the volume specified in the command.
at-volume-type
is the audit volume type specified in the command.
Cause. An ALTER AUDITTRAIL command attempted to delete a volume specified as
an at-volume-type, but this volume was not that type. For example, the command
specified DELETEACTIVEVOL (indicating an active-audit volume) when it should have
specified DELETEDOVERFLOWVOL (indicating an overflow-audit volume).
Effect. The command fails.
Recovery. Re-enter the command, using the appropriate deletion parameter. This
parameter must be set to DELETEACTIVEVOL, DELETEOVERLOWVOL, or
DELETERESTOREVOL.
Audit trails cannot be added after TMF has been started
following a DELETE TMF operation.
Volume volume could not be deleted as at-volume-type.