TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-136
Message Descriptions
511
Cause. An ENABLE BEGINTRANS command was issued without a previous
DISABLE BEGINTRANS command. BEGINTRANS could still be disabled for other
reasons, including an audit trail reaching its begin-transaction-disable threshold, or a
processor or the TMP reaching its memory threshold.
Effect. The command fails.
Recovery. Issue a STATUS BEGINTRANS command to determine the current
BEGINTRANS state. Then take corrective action, for example, adding more resources
or increasing a threshold.
512
Cause. An ALTER BEGINTRANS command specified one or more invalid values in
the TRANSCOUNTTHRESH parameter.
Effect. The command fails.
Recovery. Re-enter the command, specifying valid values for
TRANSCOUNTTHRESH.
513
Cause. An ALTER BEGINTRANS command specified one or more invalid values in
the TMFLIBMEMTHRESH parameter.
Effect. The command fails.
Recovery. Re-enter the command, specifying valid values for TMFLIBMEMTHRESH.
BEGINTRANS was already enabled by an operator command.
However, there may be other reasons why BEGINTRANS is
disabled. The STATUS BEGINTRANS command will provide that
information.
The command specified an erroneous TRANSCOUNTTHRESH value.
The command specified an erroneous TMFLIBMEMTHRESH value.