TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-149
Message Descriptions
965
Cause. A RECOVER FILES command specified the RECOVERVDPPHASE1 option,
but omitted the TOPHYSVOL option that is also required.
Effect. The command fails.
Recovery. Re-enter the command, specifying both the RECOVERVDPPHASE1 and
TOPHYSVOL options.
966
Cause. A DELETE TMF command was entered from a command file, or from the
parameter line of a TMFCOM command to start a noninteractive session. This
command, however, can only be entered interactively—that is, in response to the
TMFCOM interactive prompt character.
Effect. The command fails.
Recovery. Re-enter the command interactively.
967
Cause. A RECOVER FILES command specified, in the TOMATPOSITION option,
either too many or too few parameter values.
Effect. The command fails.
Recovery. Re-enter the RECOVER FILES command, including in the
TOMATPOSITION option both the atseqno (audit-trail file sequence number) and the
rba (relative byte address) parameters, but no others.
The RECOVER FILES command specified the RECOVERVDPPHASE1
option, which also requires a valid TOPHYSVOL option.
The DELETE TMF command was encountered in a command file or
in the command line. DELETE TMF must be run interactively.
The RECOVER FILES command supplied an incorrect number of
parameters in the TOMATPOSITION option.