TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-155
Message Descriptions
1018
Cause. A RECOVER FILES command included both the RECOVERVDPPHASE1 and
MAP NAMES options. However, you can enter only one of these in any single
command.
Effect. The command fails.
Recovery. Re-enter the RECOVER FILES command, specifying either
RECOVERVDPPHASE1 or MAP NAMES, but not both.
1050
Cause. A Subsystem Programmatic Interface (SPI) violation occurred.
Effect. The command fails.
Recovery. For a DUMP FILES, INFO DUMPS, or RECOVER FILES command, you
entered too many filenames in the file-set or NOT file-set list. In this case, re-
enter the command with fewer file names. For other commands, this message should
never appear; make a note of the command entered and then contact the GCSC or
your service provider.
1051
subtype
supplies an internal code indicating the SPI procedure that caused the error.
errcode
supplies a numeric code that further defines the error.
Cause. A Subsystem Programmatic Interface (SPI) violation occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and then contact the GCSC or your service provider.
The RECOVER FILES command specified the RECOVERVDPPHASE1
option with the MAP NAMES option. These are mutually
exclusive.
The SPI message to TMFSERVE exceeds the message buffer size.
For DUMP FILES, INFO DUMPS, or RECOVER FILES commands, there
are too many filenames in the command.
A SPI error occurred with SubType subtype, and Error errcode
while constructing the SPI message to TMFSERVE