TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-16
ADD AUDITTRAIL
add more audit volumes to the configuration later, you can use the ALTER
AUDITTRAIL command.
Volumes of the same size should be used for a specific audit trail. TMF allocates
the same number of files on each volume, and all volumes must be able to hold all
of those files. If a mixture of large and small disks is used for an audit trail, some
space on the large disks will remain unused because this space will receive neither
the active-audit trail nor the audited files. The unused space, however, could be
configured as overflow space or audit restore space.
FILESPERVOLUME integer
specifies the number of files in the audit trail that reside on each active-audit
volume configured. The audit trail’s capacity is determined by the number of audit-
trail files per volume, the number of active-audit volumes, and the file sizes. TMF
pre-allocates these files when the ADD AUDITTRAIL command is executed. If
TMF cannot allocate all the files, this command fails.
The minimum value for FILESPERVOLUME is 1 and the maximum is 100. The
default is 5.
To change the FILESPERVOLUME value later, you can use the ALTER
AUDITTRAIL command.
OVERFLOWVOL[S]
specifies the volume used as overflow space for the audit trail. Although this
attribute is not required by TMF, if you omit it, TMF issues a message at TMF
startup, indicating that an overflow-audit volume should be configured.
You can specify from 1 to 16 overflow-audit volumes. These can be the same
volumes as the active-audit volumes; they can also be data volumes or any
volumes not configured for other TMF purposes. To change the overflow-audit
volumes later, you can use the ALTER AUDITTRAIL command.
For the START TMF command to execute successfully, all overflow-audit volumes
must be up.
Note. TMF is shipped from the factory with the $AUDIT disk volume configured as the
active-audit volume. You are free to retain $AUDIT for this purpose, replace $AUDIT with
another volume as the recipient of audit trails, or add other active-audit volumes to the
configuration. See also the note about the preconfiguration of data volumes that appears
under the discussion of the ADD DATAVOLS
command.
Caution. The number of active-audit volumes multiplied by the value of FILESPERVOLUME
must be 2 or more.