TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-162
Message Descriptions
7000
Cause. The command did not specify a numeric value where TMFCOM expected one.
Effect. The command fails.
Recovery. Check the syntax rules for the command and re-enter it correctly.
7004
Cause. The command referenced a system (node) that was not configured in the
network.
Effect. The command fails.
Recovery. Re-enter the command, specifying a system defined in the network, or see
your network manager about bringing the desired system online.
7005
Cause. The command contained an improperly specified numeric parameter. A
positive number was required, but a non-numeric value or a negative number was
specified.
Effect. The command fails.
Recovery. Re-enter the command, specifying the number correctly.
7006
Cause. An ALTER PROCESS command did not specify a valid process priority in the
PRI option. A process’ priority must be from 1 through 199, inclusive.
Effect. The command fails.
Recovery. Re-enter the command, using a process priority number from 1 through
199.
Expecting a number.
Unknown system.
Illegal number.
Expecting priority in the range 1-199.