TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-172
Message Descriptions
7042
Cause. The command specified an unrecognizable optional parameter, for example a
misspelled or erroneous keyword.
Effect. The command fails.
Recovery. Check the syntax rules for the command and re-enter it accordingly.
7043
Cause. The command entered is not supported by TMFCOM.
Effect. The command fails.
Recovery. Enter the HELP ALL or HELP * command to display a list of all TMFCOM
commands, and select a valid command to enter.
7044
Cause. The command contained more than one instance of the same parameter.
Effect. The command fails.
Recovery. Re-enter the command with only one instance of this parameter.
7045
Cause. An ALTER PROCESS or ALTER CATALOG command contained a keyword
parameter that must be set to either ON or OFF, but attempted to use another value
instead. In particular, the MAKESAVEABEND, DEBUG, and INSPECT options in
ALTER PROCESS and the ROUNDROBIN option in ALTER CATALOG can only be set
to ON or OFF.
Effect. The command fails.
Recovery. Check the syntax rules for the command. Then, re-enter the command,
specifying the ON or OFF keyword as indicated.
Expecting one of CPU, PRI, SWAP, or TERM. The SWAP and TERM
options are validated but are not used.
Expecting one of ABORT, ADD, ALTER, CANCEL, CLOSE, CMDVOL,
DELETE, DISABLE, DISPLAY, DUMP, ENABLE, ENV, EXIT, FC, HELP,
HISTORY, INFO, NEXT, OBEY, OBEYVOL, OPEN, RECOVER, RELOCATE,
RESET, RESOLVE, SET, SHOW, START, STATUS, STOP, or VOLUME.
This parameter has been specified more than once.
Expecting ON or OFF.