TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-55
ALTER AUDITTRAIL
BEGINTRANSDISABLE integer
specifies the percentage of audit trail capacity that can be consumed before TMF
disables new transactions. When the consumed capacity exceeds this value, new
transactions are not allowed. When the consumed capacity falls back below this
threshold, new transactions are no longer disabled by audit-trail usage (however,
new transactions can be disabled for other reasons, as explained in the ALTER
BEGINTRANS command description).
The minimum value is 50, and the maximum is 100. The originally assigned
default is 90(%).
RESET BEGINTRANSDISABLE
resets the BEGINTRANSDISABLE attribute to the originally assigned default,
which is 90(%).
Security Restrictions
You can issue the ALTER AUDITTRAIL command only if you are a member of the
super user group.
TMF State Requirement
You can enter the ALTER AUDITTRAIL command at any time, whether or not TMF has
been started. However, after TMF is configured and started for the first time, you can
add or delete active-audit volumes or alter AUDITDUMP to OFF only while TMF is up
and running.
Usage Guidelines
Before any auxiliary audit trail can be dumped, you must configure the master audit
trail (MAT) for this purpose.
Attributes that you do not specify remain unchanged. So, if you omit an optional
parameter, one of the following actions takes place:
•
If one or more previous TMFCOM commands (such as ADD AUDITTRAIL or
ALTER AUDITTRAIL) specified the parameter, the value entered in the last of
these commands remains assigned.
•
If no previous TMFCOM command specified the parameter, the originally assigned
default remains assigned.
Note. For both online dumps and audit dumps, Expand links to remote disk volumes must
support 56 KB input/output.