TMF Reference Manual (G06.26+)

TMFCOM Commands

HP NonStop TMF Reference Manual—522418-003

3-150

DUMP FILES

The DUMP FILES command copies audited files to either tape or disk, producing

online dumps. These online dumps might be used later if file recovery is initiated

through a RECOVER FILES command.

file-set

identifies the audited files to be dumped to tape or disk. You must specifically

name alternate-key files and partitions of partitioned files in file-set if you want

them to be dumped. Nonaudited files are not dumped. If you specify the fully

qualified file name of a nonaudited file, an error message stating the file was not

dumped is displayed. Enter file-set in the following format:

[[volume.]subvolume.]file-id

DUMP FILES {file-set }

{(file-set [,file-set]...)}

{<file-name> }

[,BLOCKSIZE { 4 | 8 | 12 | 16 | 20 | 24 | 28 | 32 | 36

| 40 | 44 | 48 | 52}]

[,COPIES { 1 | 2 } [PARALLEL] ]

[,DISKMEDIA {disk }

{(disk [,disk]...)} ]

[,NOT {file-set }

{(file-set [,file-set]...)}

{<file-name> } ]

[,START start-file ]

[,TAPEMEDIA {tape-volume }

{(tape-volume [,tape-volume]...)} ]

[,SYSTEM {node }

{(node, node)} ]

[,UNLOAD { ON | OFF } ]

[,VERIFYTAPE { ON | OFF } ]