TMF Reference Manual (G06.26+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-003
3-180
INFO AUDITTRAIL
Usage Guideline
The INFO AUDITTRAIL command displays a subset of the information presented by
the INFO TMF command.
Output Displayed
The INFO AUDITTRAIL command displays the attributes configured for the audit trails
by ADD DATAVOLS and ALTER AUDITTRAIL commands entered previously. The
primary items in the display are listed in Table 3-10.
Table 3-10. INFO AUDITTRAIL Output
Heading or Item Description
Master/Auxnn Configuration Audit trail for which information is displayed.
ActiveVols Active-audit volumes on which active-audit trail is stored.
Subvolume Subvolume in which audit trail is stored (always ZTMFAT).
Prefix Prefix used in audit trail identifier; TMF assigns the prefix
AA to MAT files and the prefixes BB through PP to files in
each of the auxiliary audit trails.
filesize Size of the audit-trail files, in megabytes.
filespervolume Number of files in audit trail that reside on each active-audit
volume configured.
auditdump on/off Indication of whether audit dumping is performed for audit
trail.
overflowthreshold Percentage of active-audit trail capacity above which TMF
begins overflow copying.
begintransedisable Percentage of active-audit trail capacity that can be
consumed before new transactions are disabled.
MaxRetainedATFiles Maximum number of audit-trail files to be retained on
restore-audit volumes indefinitely after recovery processes
no longer need them.
commitholdmode Commit-hold mode status (ON or OFF); ON permits
commit-hold activation if needed; OFF prevents commit-
hold activation. If this status is not displayed, your
TMFCOM is communicating with an earlier version of
TMFSERVE that does not recognize COMMITHOLDMODE,
you have never set COMMITHOLDMODE after configuring
your TMF system, or you have reset the value of
COMMITHOLDMODE after you had previously set this
value.