TMF Reference Manual (G06.26+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-003
3-209
INFO TAPEMEDIA
available with all commands. Subsequently executing this command file produces
tape media entries in the catalog that exactly match the existing entries. (The ADD
TAPEMEDIA commands created by the OBEYFORM option specify STATUS
SCRATCH regardless of the actual tape status, so that all tapes specified can be
added back into the catalog.) The use of the OUT option and command file
execution are described under Directing Output to an Alternate Destination on
page 2-8. If OBEYFORM is not specified, normal formatting is used.
Security Restrictions
Anyone can enter the INFO TAPEMEDIA command.
TMF State Requirement
Before you can enter the INFO TAPEMEDIA command, TMF must be started.
Output Displayed
The INFO TAPEMEDIA command displays entries in the catalog recorded by ADD
TAPEMEDIA and ALTER TAPEMEDIA commands entered previously. The primary
items in the display are listed in Table 3-17.
Example
The following INFO TAPEMEDIA command shows the type and status of all tape
volumes in the catalog:
TMF 30> INFO TAPEMEDIA
Media Name Media Type Media Status
--------------------------------------
PLU000 tape assigned
PLU001 tape assigned
PLU002 tape assigned
PLU003 tape assigned
PLU004 tape assigned
PLU005 tape assigned
PLU006 tape scratch
PLU007 tape scratch
PLU008 tape scratch
Table 3-17. INFO TAPEMEDIA Output
Heading or Item Description
Media Name Name (identifier) of tape volume.
Media Type Type of media (always “tape”).
Media Status Status of tape volume: ASSIGNED, BAD, RELEASED, or SCRATCH.