TMF Reference Manual (G06.26+)
TMFCOM Commands
HP NonStop TMF Reference Manual—522418-003
3-275
SET TAPEMEDIA
SET TAPEMEDIA
The SET TAPEMEDIA command establishes attribute values for tape volumes added
by subsequent ADD TAPEMEDIA commands issued during the same TMFCOM
session.
DENSITY density
specifies the density at which tapes are written. See Section 4, TMFCOM Tape
Media Considerations, for the density settings appropriate for the kind of tape drive
you are using.
DRIVE [node.]tape-drive
identifies the tape drive on which you want to label tape volumes. Guardian
labeled-tape processing must be enabled on the node (system) specified in node.
This parameter is required for labeling tapes.
node
is the name of the local or remote node. The syntax rules for specifying a node
name appear under Disk File Names, earlier in this section. The default is your
local node.
tape-drive
is the name of the tape drive.
SET TAPEMEDIA attribute [,attribute] ...
where attribute is:
[DENSITY density]
[DRIVE [node.]tape-drive]
[LABEL {ON [!] | OFF}]
[STATUS {ASSIGNED}
{BAD }
{RELEASED}
{SCRATCH }]
[UNLOAD {ON | OFF}]