TMF Reference Manual (G06.26+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-003
3-299
STATUS AUDITTRAIL
Commit-Hold
Status
The COMMITHOLD attribute setting, as follows:
OFF
COMMITHOLDMODE is set OFF; the commit-hold condition
cannot be enabled, activated, or suspended.
ENABLED
COMMITHOLDMODE has been set ON, and transaction
completion can take place normally. ENABLED is the normal
COMMITHOLD status. However, the commit-hold condition can
now be activated if conditions on the backup system require it.
ACTIVATED
The commit-hold condition is activated and transaction commits
and aborts are currently on hold. The duration timeout, if
specified, is now in effect and the duration timer is counting down.
When commit-hold status is ACTIVATED, the display shows the
disk process that first activated the commit-hold, the time that the
hold began, the timeout duration, and the timeout action to be
taken. If the audit trail has not been suspended from commit-hold
mode during ACTIVATED status, the display also includes a
warning about the effect of ACTIVATED status on transaction
processing.
REVIVING
Although ZLT could not be guaranteed and the audit trail entered
the ACTIVATED state, the disk process can now access the
remote mirror successfully and is synchronizing it with the primary
mirror. Once this synchronization is complete, ZLT can be
guaranteed once more. The display shows the name of the disk
process currently being revived, the time at which this process
started, the timeout duration remaining, and the timeout action to
be taken.
The Commit-Hold item is not displayed if:
•
TMFCOM is communicating with an earlier version of TMFSERVE
that does not recognize the COMMITHOLD attribute, or
•
The COMMITHOLDMODE and COMMITHOLDTIMER options
have not been used after your TMF system was configured, or
you have reset these options.
Table 3-21. STATUS AUDITTRAIL Output (page 5 of 5)
Heading or Item Description