TMF Reference Manual (G06.26+)

TMFCOM Messages

HP NonStop TMF Reference Manual—522418-002

A-6

Message Descriptions

The numbered messages are described in the following pages.

tape-volume

is the invalid tape-volume name.

part

for a command dealing with a dump, identifies the portion of the dump stored on

this tape volume.

copy

for a command dealing with a dump, identifies the copy number of the dump stored

on this tape volume.

Cause. The command specified an invalid tape-volume name or failed to supply the

part:copy specifier when it was required. The tape-volume name refers to the tape

identifier magnetically encoded on the tape. Perhaps the name used in the command

was too long or contained improper characters.

Effect. The command fails.

Recovery. Verify that the tape-volume name complies with the following syntax rules:

•

The name must begin with a digit or a letter.

•

If the name begins with a digit, up to five more digits can follow.

•

If the name begins with a letter, up to five digits or letters in any combination can

follow. (Either uppercase or lowercase letters are permitted.)

Re-enter the command with a correct tape-volume name or with the part:copy

specifier, if required.

The command specified an invalid TAPEMEDIA name, tape-volume.

If this name begins with a digit, all characters must be

digits. If this name begins with a letter, subsequent

characters can be alphanumeric. Also, the command might

require the “part:copy” specification.