TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-18
Message Descriptions
50
Cause. The command specified an invalid RETAINDEPTH parameter used to
determine the number of online dump generations that can remain in the catalog. The
number specified can range from 1 to 99.
Effect. The command fails.
Recovery. Re-enter the command, using a RETAINDEPTH value of from 1 through
99.
51
Cause. The command specified an invalid RELEASED parameter used to indicate
whether an online or audit dump file is available for file recovery. This parameter can
be set to OFF (to indicate that the file is available) or ON (to indicate that it is not
available).
Effect. The command fails.
Recovery. Re-enter the command, specifying only either ON or OFF for the
RELEASED parameter.
52
Cause. The command specified an invalid TAPEMEDIA STATUS parameter used to
set the status of a tape volume, thus determining its availability for use in dumping.
The STATUS parameter can indicate one of the following keywords only: RELEASED,
ASSIGNED, BAD, or SCRATCH.
Effect. The command fails.
Recovery. Re-enter the command, setting STATUS to RELEASED, ASSIGNED, BAD,
or SCRATCH. For further information about these values, see the INFO TAPEMEDIA
command description in Section 3, TMFCOM Commands.
The command specified an invalid RETAINDEPTH parameter.
RETAINDEPTH must specify a value in the range 1 to 99,
inclusive.
The command specified an invalid RELEASED parameter.
The command specified an invalid TAPEMEDIA STATUS parameter.