TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual522418-002
A-33
Message Descriptions
108
Cause. A Subsystem Programmatic Interface (SPI) error occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and the circumstances. Then, contact the GCSC or your service provider.
109
Cause. The command did not specify a valid audit-trail sequence number. This
sequence number must be the numeric portion of the audit-trail file name, with leading
zeros optional, ranging from 1 through 999999.
Effect. The command fails.
Recovery. Re-enter the command, using a valid audit trail sequence number.
110
Cause. A STATUS OPERATIONS command specified a value other than
INPROGRESS, FINISHED, or ALL for the STATE parameter.
Effect. The command fails.
Recovery. Re-enter the command with STATE set to INPROGRESS, FINISHED, or
ALL.
111
Cause. A STATUS OPERATIONS command specified an improper value for the TYPE
parameter. (See the command syntax description for the list of acceptable values.)
Effect. The command fails.
Recovery. Re-enter the command with TYPE set to a proper value.
Subsystem Error: A STATUS TRANSACTION command specified the
STATUS DETAIL option with an illegal value. Contact the
Global Customer Support Center (GCSC) or your service
provider.
Expecting audit trail sequence number between 1 and 999999.
The command specified an erroneous STATE value.
The command specified an erroneous TYPE value.