TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-41
Message Descriptions
129
volume
is the name of the volume specified in the command.
Cause. An ADD AUDITTRAIL command specified a restore-audit volume name that
was not valid. For example, perhaps the name was too long or contained wild-card
characters.
Effect. The command fails.
Recovery. Check the syntax rules for the RESTOREVOL[S] parameter of the ADD
AUDITTRAIL command. Then, re-enter the command, using an appropriate volume
name.
130
volume
is the name of the volume specified in the command.
Cause. The command referred to a volume name that was not valid within the context
of this command. For example, perhaps the command used a remote volume name
where only local names are permitted or specified a name containing wild-card
characters where only complete names are permitted.
Effect. The command fails.
Recovery. Check the syntax rules for the command. Then, re-enter the command,
using an appropriate volume name.
131
Cause. A TMF error occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and the circumstances. Then, contact the GCSC or your service provider.
The volume name volume, for a volume being added as a restore
audit volume, is invalid.
The volume name volume is invalid in the context used.
Subsystem Error: No AuditTrailId was specified.