TMF Reference Manual (G06.26+)
TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-43
Message Descriptions
136
Cause. An ADD AUDITTRAIL or ALTER AUDITTRAIL command specified a value for
the OVERFLOWTHRESHOLD parameter that did not fall within the proper limit, an
integer from 50 to 100. This parameter determines the percentage of audit trail
capacity in use above which TMF begins overflow copying.
Effect. The command fails.
Recovery. Re-enter the command, setting OVERFLOWTHRESHOLD to an integer
from 50 to 100 or omitting this parameter altogether so that the default value of 80
(percent) applies.
137
Cause. An ADD AUDITTRAIL or ALTER AUDITTRAIL command specified a value for
the BEGINTRANSDISABLE parameter that did not fall within the proper limit, an
integer from 50 to 100. This parameter determines the percentage of audit-trail
capacity that can be consumed before TMF disables new transactions.
Effect. The command fails.
Recovery. Re-enter the command, setting BEGINTRANSDISABLE to an integer
ranging from 50 to 100 or omitting this parameter altogether so that the default value of
90 (percent) applies.
138
Cause. A TMF error occurred.
Effect. The command fails.
Recovery. This command should never appear. Make a note of the command
entered and the circumstances. Then, contact the GCSC or your service provider.
The value specified for OVERFLOWTHRESHOLD is invalid.
The value specified for BEGINTRANSDISABLE is invalid.
Subsystem Error: The specified volume type for the audit-
trail volume is invalid.