TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-61
Message Descriptions
215
Cause. This command should only be issued when TMF is not running.
Effect. The command fails.
Recovery. Enter a STOP TMF command to shut down TMF in an orderly way. Then,
enter the command that resulted in this error message.
236
Cause. The command specified an invalid value for the AUTOABORT parameter.
Effect. The command fails.
Recovery. Re-enter the command, specifying either an appropriate timeout value
for the AUTOABORT parameter, or 0 to turn the autoabort feature off. The timeout
value can range from 20 seconds to one of the following maximum values: 21474836
seconds, 357913 minutes, or 5965 hours. For more information about the timeout
value, see the ALTER BEGINTRANS command description in Section 3, TMFCOM
Commands.
249
Cause. This command cannot be entered before TMF is configured.
Effect. The command fails.
Recovery. Ask your system manager to configure TMF through system generation. If
necessary, also start TMF. Then, re-enter this command.
253
Cause. You entered a command that can only be issued while TMF is running.
Effect. The command fails.
Recovery. Start TMF and then re-enter this command.
TMF must be stopped before this command can be used.
The ALTER BEGINTRANS command specified an invalid AUTOABORT
parameter. AUTOABORT must indicate either a timeout value in
the proper range or OFF.
TMF must be configured. Configuration is performed through
system generation.
This command can only be used when TMF is ACTIVE or STOPPING.