TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-132
Message Descriptions
453
Cause. TMFCOM received a command while TMF was performing an ALTER TMF,
CONFIGVOL operation.
Effect. The command fails.
Recovery. Wait until the ALTER TMF, CONFIGVOL operation completes and then re-
enter the command.
454
fserrcode
is the File System error number.
Cause. An ALTER TMF command failed while accessing the configuration volume
because a File System error occurred.
Effect. The command fails.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for a
description of, and recovery actions for, the File System error. Determine why the
problem occurred, correct it, and retry the command.
455
Cause. An ALTER TMF, SWITCHPROCESS command attempted to switch the
primary and backup TMPs, but the operation failed because the audit-trail files were
full or because commit-hold was activated.
Effect. The command fails.
Recovery. If the audit-trail files are full, increase the space available for audit-trail files
by adding an overflow-audit volume to the MAT or increasing the FILESPERVOLUME
value. If commit-hold is activated, wait until the problem that caused the activation is
corrected, or suspend or turn off COMMITHOLDMODE.
The command specified could not be executed because an ALTER
TMF, CONFIGVOL command was already in progress.
The command specified failed because file system error
fserrcode occurred while accessing the configuration volume
file.
The SwitchProcess command cannot complete because the audit
trail files are full. The command is rejected. Add an
overflowvol to the MAT or increase the FilesPerVolume value.
Also, SwitchProcess command cannot be completed if CommitHold
is activated for any audit trail.