TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-138
Message Descriptions
474
at-id
is the audit-trail identifier.
Cause. An ALTER TMF command attempted to change the audit-trail format from
format 2 to format 1, but the FILESIZE of the audit trail at-id exceeds 2047 MB and
is thus too large to support format 1.
Effect. The command fails.
Recovery. Do not attempt to change the ATFORMAT value for your TMF
configuration.
475
filename
is the name of the file.
Cause. An ALTER TMF command attempted to change the audit-trail format from
format 2 to format 1, but the audit-trail file named filename exceeds 2047 MB and
the file is thus too large to support format 1.
Effect. The command fails.
Recovery. Do not attempt to change the ATFORMAT value for your TMF
configuration.
481
Cause. A Subsystem Programmatic Interface (SPI) violation occurred.
Effect. The command fails.
Recovery. This message should never appear in TMFCOM. Make a note of the
command entered and the circumstances. Then, contact the GCSC or your service
provider.
The ATFORMAT cannot be changed to format 1 because the file
size of at-id audit trail exceeds the format 1 limit of 2047.
The ATFORMAT cannot be changed to format 1 because the size
of the audit trail file filename exceeds the format 1 limit
of 2047 megabtyes.
The TmpWaitTimer option is invalid. Expecting Off, Auto, or
number greater than 9999 and less than 1000001.