TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-184
Message Descriptions
7014
Cause. A RECOVER FILES command did not specify a valid audit-trail sequence
number in the TOMATPOSITION parameter. This sequence number must be the
numeric portion of the MAT file name, with leading zeros optional, ranging from 1
through 999999.
Effect. The command fails.
Recovery. Re-enter the command, using a valid audit trail sequence number.
7015
Cause. A RECOVER FILES command did not specify a valid relative byte address
(rba) in the TOMATPOSITION parameter. This rba must be a number ranging from 0
through 2147483647.
Effect. The command fails.
Recovery. Re-enter the command, using a valid rba.
7016
Cause. An ADD DUMPS command did not specify a valid number of copies in the
TAPEMEDIA option. This value must be either 1 or 2.
Effect. The command fails.
Recovery. Re-enter the command, specifying a valid number of copies.
7017
Cause. An ADD DUMPS command did not specify a valid part number in the
TAPEMEDIA parameter, indicating which part of the dump should be stored on the
volume. This value must be a number greater than zero.
Effect. The command fails.
Recovery. Re-enter the command, specifying a valid dump part number.
Expecting audit trail sequence number between 1 and 999999.
Expecting audit trail RBA number between 0 and 2147483647.
Expecting TAPEMEDIA copy number between 1 and 2.
Expecting TAPEMEDIA part number; value must be greater than
zero.