TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-208
Message Descriptions
7117
Cause. A VOLUME command specified a disk volume on a node other than the local
node.
Effect. The command fails.
Recovery. Check the syntax rules for the command. Then, re-enter the command,
specifying a local disk volume.
7118
Cause. An ALTER PROCESS command specified an integer1 value for the
EXTENDEDSEGIZE parameter that was outside the range allowed for the process. In
general, TMFCOM accepts values between 1 and 128, but the minimum value actually
allowed in specific cases depends on the process type and software release.
Effect. The command fails.
Recovery. Check the syntax rules for the command. Then, re-enter the command,
specifying an integer1 value in the correct range.
7119
Cause. An ALTER PROCESS command specified an integer2 value for the
EXTENDEDSEGIZE parameter that was outside the range allowed for the process. In
general, TMFCOM accepts values between 1 and 128, but the minimum value actually
allowed in specific cases depends on the process type and software release.
Effect. The command fails.
Recovery. Check the syntax rules for the command. Then, re-enter the command,
specifying an integer2 value in the correct range.
Unable to use an 8-character volume name as the default.
Expecting EXTENDEDSEGSIZE integer1 value between 1 and 128.
The minimum value for integer1 depends on the process type
and software release.
Expecting EXTENDEDSEGSIZE integer2 value between 1 and 128.
The minimum value for integer2 depends on the process type
and software release.