TMF Reference Manual (G06.26+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-211
Message Descriptions
7127
Cause. The command contained a file specifier that was too long.
Effect. The command fails.
Recovery. Verify that the file specifier complies with the syntax rules listed in File
Names and Process Identifiers on page 3-6. Then, re-enter the command, ensuring
that the file specifier does not violate its length limit.
7128
Cause. An FC command attempted to repeat or correct a previously entered
command, but no preceding commands exist in the command buffer; this FC command
was the first command entered in this TMFCOM session.
Effect. None; informative message only.
Recovery. None required.
7129
Cause. The command included a parameter that contained wild-card characters, but
such characters are prohibited for this parameter.
Effect. The command fails.
Recovery. Check the syntax rules for the command and re-enter it correctly.
7130
Cause. The command specified a filename that included an element other than a legal
volume name, subvolume name, or file identifier.
Effect. The command fails.
Recovery. Verify that the volume name, subvolume name, or file identifier complies
with the syntax rules listed in File Names and Process Identifiers on page 3-6. Then,
re-enter the command, following these rules.
Maximum length exceeded.
No previous command to FC.
Wild-card characters not allowed.
The filename must be restricted.
[[{volume|*}.]{subvolume|*}.]{file-id|*}