TMF Supplement for Large Audit Files (G06.24+)

TMF Reference Manual
HP NonStop TMF Supplement for Large Audit-Trail Files—527391-001
5-50
Message Descriptions (New Discussion)
Message Descriptions
(New Discussion)
The following messages are new, although some replace existing messages as noted.
107
Cause. A TMF error occurred.
Effect. The command fails.
Recovery. This message should never appear in TMFCOM. Make a note of the
command entered and the circumstances. Then, contact the GCSC or your service
provider.
470
Cause. The command specified a value for the FILESIZE parameter that exceeded
2047 for format 1 files or 1048575 for format 2 files. This parameter specifies the size
of the audit-trail files, in megabytes.
Effect. The command fails.
Recovery. Re-enter the command, setting FILESIZE to an integer from 1 to 1048575,
or omitting this parameter altogether so that the default value (100 for format 1 files or
1024 for format 2 files) applies.
471
Cause. The ALTER TMF, ATFORMAT command was issued, but either TMF is still
running or it was stopped with a STOP TMF, ABRUPT command.
Effect. The command fails.
Recovery. If necessary, restart TMF. Then, enter a STOP TMF command to shut
down TMF in an orderly way, and, finally, issue the ALTER TMF, ATFORMAT
command.
Expecting audit trail RBA number between 0 and 1048575
Megabytes (in bytes).
The value specified for FILESIZE is invalid for the current
audit trail format.
Note. This message replaces TMFCOM Message 135.
The ATFORMAT can only be changed when TMF is stopped cleanly.
Start and stop TMF again without specifying the ABRUPT
option.