TN3270 Server Manual

System Setup

TN3270 Server Manual—424097-001

2-3

Installing the Guardian TN3270 Server

Follow these steps to install the Guardian TN3270 Server:

1. If you are using Install (D-series installations only) to install the Guardian TN3270

Server:

Perform the RESTDSV, SYSGEN, and REPSUBSYS phases of the Install program.

If you are using DSM/SCM (for D-series and G-series installations) to install the

Guardian TN3270 Server:

See the DSM/SCM User’s Guide for detailed information about DSM/SCM

installation methods.

2. Start the TCP/IP process.

Use the Subsystem Control Facility (SCF), as shown next, to set the TCP/IP host

name if it is not already set.

3. Start the Guardian TN3270 Server.

4. Connect to the Guardian TN3270 Server from a TN3270 client.

Defining the TCP/IP Host Name

Use the following procedure to define the IP host name before bringing up the Guardian

TN3270 Server.

Use SCF to set the TCP/IP HOSTNAME attribute, as follows:

TACL 1> SCF

1-> ASSUME PROCESS tcpip-process

2-> ALTER,HOSTNAME "host-name"

ZTN3TAL ZSPIDEF 101 SPI/EMS definitions file for TAL

ZTN3TMPL ZTEMPL 844 DSM templates file

ZTN3SEGF ZSPISEGF 440 TACL file segment with EMS/SPI definitions

Note. You can continue to use Install for your D-series system software installations. Be

advised, however, that dates may not be displayed properly. Tandem advises that you use

DSM/SCM to avoid this inconvenience. For G-series system software installations, you

must use DSM/SCM.

Note. Be sure to include the quote marks when entering the ALTER,HOSTNAME “host-

name” command.

Table 2-2. Guardian TN3270 Server Files (page 2 of 2)

File Name Location Type Description