Token-Ring Adapter Installation and Support Guide

Installing the TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
2-11
Unpack and Install the New TRSA
Install the TRSA
The following steps explain how to insert the TRSA into the system enclosure.
1. With the ejector on the TRSA in the full-open position (Figure 2-6
), grasp the TRSA
by the ejector with one hand and support the bottom edge of the TRSA with the
other hand (Figure 2-7 on page 2-12). Hold the adapter so that its ejector is at the
top, as shown in Figure 2-6, and insert the adapter into the upper part of the carrier.
2. Push the TRSA to the rear of the slot, but don't force it.
3. Press the blue-green tab on the TRSA ejector and latch the ejector to seat the TRSA
against the backplane.
Figure 2-6. Ejector Shown in Full-Open Position
Caution. Apply equal pressure to both the top and bottom of the TRSA when pushing it into
the slot to avoid damaging the connector pins. If pins are damaged, both the TRSA and the
backplane (or enclosure) must be replaced.
CDT500.CDD