Token-Ring Adapter Installation and Support Guide

Replacing a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
3-21
Unpack and Install the New TRSA
3. Press the blue-green tab on the TRSA ejector and latch the ejector to seat the TRSA
against the backplane.
4. Disconnect the grounding clip of your ESD wriststrap from the enclosure.
5. Connect the communications cable to the TRSA. You can connect an RJ-45
connector to the Token-Ring Connector UTP port or a DB-9 connector to the
Token-Ring Connector STP port. See Figure 3-8
for connections.
Figure 3-7. Installing a TRSA
058CDT .CDD