Token-Ring Adapter Installation and Support Guide

Replacing a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
3-26
Start the New TRSA
Verify that Objects Are in the Started State
Use the following SCF STATUS commands:.
1. Verify that the TRSA object is in the STARTED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $ZZLAN.adapter-name
Example 3-16
shows the output of the SCF STATUS ADAPTER command.Note
that the ADAPTER is in the STARTED state.
2. Verify that the ServerNet addressable controller (SAC) is in the STARTED state.
Use the SCF STATUS SAC command:
STATUS SAC $ZZLAN.adapter-name.*
Example 3-17 shows the output of the SCF STATUS SAC command. Note that the
ServerNet adressable controller (SAC) is in the STARTED state.
3. Verify that the physical interface (PIF) is in the STARTED state.
Use the SCF STATUS PIF command:
STATUS PIF $ZZLAN.adapter-name.*
Example 3-18
shows the output of the SCF STATUS PIF command. Note that the
physical interface (PIF) is in the STARTED state.
Example 3-16. SCF STATUS ADAPTER Command
-->STATUS ADAPTER $ZZLAN.E0153
SLSA Status ADAPTER
Name State
$ZZLAN.E0153 STARTED
Example 3-17. SCF STATUS SAC Command
-> STATUS SAC $ZZLAN.E1053.*
SLSA Status SAC
Name Owner State Trace Status
$ZZLAN.E1053. 0 0 STARTED OFF
$ZZLAN.E1053. 1 0 STARTED OFF
Example 3-18. SCF STATUS PIF Command
--> STATUS PIF $ZZLAN.E0153.*
SLSA Status PIF
Name State Trace Status
$ZZLAN.E0153.0.A STARTED OFF