Token-Ring Adapter Installation and Support Guide

Replacing a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
3-29
Verify That the Communications Lines Are Started
Verify That the Communications Lines Are Started
Perform the following steps to make sure that the communications lines that use the
TRSA are started
1. Verify that the TCP/IP subnet is started.
Use the SCF STATUS SUBNET command:
STATUS SUBNET $tcpip-process-name.#subnet-name
Example 3-19 shows the output of this command. Note that the TCP/IP subnet
(#SN2) is in the STARTED state.
2. Verify that an IPXPROTO process is started,.
Use the SCF STATUS PROCESS command:
STATUS PROCESS $process-name
Example 3-21 shows the output of this command. Note that the IPXPROTO process
($ZNV2) is in the STARTED state.
3. Verify that a Port Access Method (PAM) line is started.
use the SCF STATUS LINE command:
STATUS LINE $line-name
Example 3-22 shows the output of this command. Note that the Port Access Method
(PAM) line ($TOK1) is in the STARTED state
Note. To verify a TCP/IP subnet that is configured using Parallel Library TCP/IP, refer to the
TCP/IP (Parallel Library) Configuration and Management Manual.
Example 3-20. SCF STATUS SUBNET Command
->STATUS SUBNET $ZTC01.#SN2
TCPIP Status SUBNET \COWBOY.$ZTC01.#SN2
Name Status
#SN2 STARTED
Example 3-21. SCF STATUS PROCESS Command
->STATUS PROCESS $ZNV2
IPXSPX Status PROCESS
Process Name State Diagnostic State Trace
$ZNV2 STARTED NORMAL OFF
Example 3-22. SCF STATUS LINE Command
->STATUS LINE $TOK1
Primary Backup
Name State CPU PIN CPU PIN TRACE
$TOK1 STARTED 1 278 -1 -1 OFF