Token-Ring Adapter Installation and Support Guide

Replacing a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
3-30
Troubleshooting: If an Object is Not in the STARTED
State
4. Verify that the SNAX/TR line is in the STARTED state.
Use the SCF STATUS LINE command:
STATUS LINE $line-name
Example 3-23 shows the output of this command. Note that the SNAX/TR line
($TRS1) is in the STARTED state
Troubleshooting: If an Object is Not in the STARTED State
If an object is not in the STARTED state, check for event messages in the Event
Message Service (EMS) log. Use the TSM EMS Event Viewer Application to view the
EMS log:
1. From the File menu, select Log on.
2. Select the system.
3. Type the NonStop™ Kernel user name and password.
4. Click OK.
5. From the Setup menu, select Timeframe, Source, or Subsystem criteria, or all three.
Refer to the Operator Messages Manual for cause, effect, and recovery information for
event messages.
Resume Customer Applications
To resume customer applications, perform the following:
1. Perform any actions necessary to resume customer applications.
2. Notify end users that applications are now available.
Example 3-23. SCF STATUS LINE Command
->STATUS LINE $TRS1
SNAX Status LINE
Name State Inuse LinState
$TRS1 STARTED OFF INACTIV
Note. The actions required to perform this step depend on the customer's application.