Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-6
Identify Any Communications Lines Using the TRSA
4. Determine the PAM lines associated with the LIF on the TRSA to be relocated.
a. Use the SCF INFO LINE command for each PAM line you identified in Step 3:
INFO LINE $line-name
b. Check the output for the LIF on the TRSA to be relocated. On the TRSA
Planning Worksheet on page 4-3, record the PAM lines associated with the LIF
on the TRSA.
Example 4-4
shows the output of this command. The LIF name is shown in the
LIF NAME column. The type of CRU is shown in the LIF TYPE column. The
LIF type is TR. In this example, the TRSA LIF named L01C is associated with
the PAM line named $TOK1.
5. Identify the SNAX/TR lines configured on the system. Use the following SCF
LISTDEV command to display the SNAX/TR lines:
LISTDEV TYPE 58,4
In Example 4-5, two SNAX/TR lines, one named $TRS1 and one named $TRS2, are
configured on the system.
Example 4-3. SCF NAMES Command
->NAMES $ZZPAM
PAM Names PROCESS \SAMCAT.$ZZPAM
PROCESS
$TOK1 $ZZPAM
LINE
$TOK1
PORT
$TOK1.#L1P0002 $TOK1.#L1P0004
MSAP
$TOK1.#SNATR
Example 4-4. SCF INFO LINE Command
->SCF INFO LINE $TOK1
PAM Info LINE
Name MAXREQUESTSIZE LIF NAME LIF TYPE LIF MAC ADDRESS
$TOK1 3200 L01C TR 08:00:8E:00:D1:95
Example 4-5. SCF LISTDEV Command
->LISTDEV TYPE 58,4
LDev Name PPID BPID Type Rsize Pri Program
109 $TRS1 3,9 2,7 (58,4) 3 199 \COWBOY.$DATA00.T9057ADJ.SNATSOBJ
159 $TRS2 0,16 1,15 (58,4) 3 199 \COWBOY.$DATA00.T9057ADJ.SNATSOBJ