Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-7
Identify Any Communications Lines Using the TRSA
6. Determine if any SNAX/TR lines configured on the system use the TRSA to be
relocated.
a. Use the SCF INFO LINE command with the SUB PU and
ASSOCIATESUBDEV options for each SNAX/TR line you identified in Step
5:
INFO LINE $line-name, SUB PU, ASSOCIATESUBDEV
b. Scan the output of the command for the names of the PAM lines you identified
in Step 4. On the TRSA Planning Worksheet on page 4-3, record the SNAX/TR
lines that use the PAM lines.
Example 4-6
shows the output of this command. The AssociateSubDev
attribute shows the name of the PAM line associated with the SNAX/TR line. The
SNAX/TR line named $TRS1 is associated with the PAM line named $TOK1.
7. Identify the IPXPROTO processes configured on the system.
Use the SCF NAMES SUBSYS command:
NAMES SUBSYS $ZMGR
Example 4-7 on page 4-8 shows the output of this command. IPXPROTO
process names are shown under the PROCESS heading. The two configured
IPXPROTO processes are named $ZNV0 and $ZNV1.
Example 4-6. SCF INFO LINE Command with SUB PU and ASSOCIATESUBDEV
Options
->INFO LINE $TRS1, SUB PU, ASSOCIATESUBDEV
SNAX Detailed Info PU \CHIP.$TRS1.#P041
AssociateSubDev.. \CHIP.$TOK1.#PO41
SNAX Detailed Info PU \CHIP.TRS1.#P042
AssociateSubDev.. \CHIP.$TOK1.#P042
SNAX Detailed Info PU \CHIP.TRS1.#P083
AssociateSubDev.. \CHIP.$TOK1.#P083
SNAX Detailed Info PU \CHIP.TRS1.#P084
AssociateSubDev.. \CHIP.$TOK1.#P084