Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-9
Redirect or Stop Any Customer Applications Using
the TRSA
Redirect or Stop Any Customer Applications Using the TRSA
To redirect or stop customer applications, perform the following steps:
1. Notify end users that applications will be temporarily unavailable.
2. Perform any actions necessary to redirect or stop customer applications.
Stop the Communications Lines Using the TRSA
To stop the communications lines that use the TRSA, perform the following steps:
To Stop a SNAX/TR Line
The following steps describe stopping a SNAX/TR line.
1. Abort the SNAX/TR line.
Use the SCF ABORT LINE command:
ABORT LINE $line-name
2. Verify that the SNAX/TR line is in the STOPPED state.
Use the SCF STATUS LINE command:
STATUS LINE $line-name
Example 4-9 shows the output of this command. Note that the SNAX/TR ($TRS1)
line is in the STOPPED state.
3. Stop the WAN IOP.
Use the SCF STOP DEVICE command:
STOP DEVICE $ZZWAN.#line-name
4. Verify that the WAN subsystem IOP is stopped.
Use the SCF STATUS DEVICE command:
STATUS DEVICE $ZZWAN.#line-name
Note. The actions required to perform this step depend on the customer’s application.
Example 4-9. SCF STATUS LINE Command
->STATUS LINE $TRS1
SNAX Status LINE
Name State Inuse LinState
$TRS1 STOPPED OFF INACTIV