Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-14
Locate the New Slot
5. Verify that the TRSA ADAPTER object is in the STOPPED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $adapter-name
Example 4-16 shows the output of this command. Note that the ADAPTER
(E0153) is in the STOPPED state.
Locate the New Slot
Find the group, module, and slot containing the TRSA you want to move and the empty
slot to which you want it moved. The empty slot contains a double-high filler panel.
(Figure 4-2
on page 4-15 shows the TRSA slot locations.)
Remove the double-high filler panel from the slot to which you want to move the TRSA.
Set the filler panel aside. You will reinstall the filler panel in the slot left vacant by the
TRSA you move.
Label the Communications Cable Connected to the TRSA
You now must label the communications cable for the TRSA. Perform the following
steps:
1. Use your worksheet with you to help find the physical locations of group, module,
and slot in which the TRSA is installed.
Figure 4-2
on page 4-15 shows the TRSA slot locations.
Example 4-16. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZLAN.E0153
SLSA Status ADAPTER
Name State
$ZZLAN.E0153 STOPPED