Token-Ring Adapter Installation and Support Guide

Relocating a TRSA

Token-Ring Adapter Installation and Support Guide—426955-001

4-18

Remove and Install the Adapter

The following steps describe how to remove a TRSA and then install it in a new

location.

1. Disconnect the communications cables from the TRSA.

2. Put on your electrostatic discharge (ESD) wriststrap and connect the grounding clip

securely to an exposed, unpainted, metal surface on the service side of the system

enclosure, such as the processor multifunction (PMF) adapter or I/O multifunction

(IOMF) adapter ventilation holes.

Figure 4-4

shows how to connect the grounding clip to the ventilation holes on the

PMF adapter or IOMF adapter.

3. Unlatch the ejector on the TRSA by pressing the blue-green tab on the ejector and

pulling the ejector outward to unseat the TRSA from the backplane.

4. Grasp the TRSA by its ejector in one hand and slowly pull the TRSA out of the slot

while supporting the bottom edge of the TRSA with the other hand.

Figure 4-4. Grounding Clip

Note. The TRSA weighs 6.75 pounds (3 kilograms).

081CDT .CDD

Processor Multifunction (PMF) CRU or

I/O Multifunction (IOMF) CRU

Grounding

Clip

To Grounding

Wriststrap