Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-19
Remove and Install the Adapter
Figure 4-5 shows how to pull the adapter out of the slot.
5. Move the TRSA to the new slot.
a. Disconnect the grounding clip of your ESD wriststrap from the system
enclosure and connect to an exposed, unpainted surface on the TRSA.
b. Grasp the TRSA by its ejector in one hand, support the bottom edge of the
TRSA with the other hand. Carry the TRSA to the slot where it is to be installed.
Figure 4-5. Removing a TRSA
Note. The TRSA weights 6.75 pounds (3 kilograms)
059CDT .CDD