Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-21
Remove and Install the Adapter
9. Press the blue-green tab on the TRSA ejector and latch the ejector to seat the TRSA
against the backplane.
10. Disconnect the grounding clip of your ESD wriststrap from the enclosure.
11. Install the double-high filler panel in the slot left vacant by the TRSA you moved.
12. Connect the communications cable to the TRSA. You can connect an RJ-45
connector to the Token-Ring Connector UTP port or a DB-9 connector to the
Token-Ring Connector STP port.
Figure 4-7. Installing a TRSA
058CDT .CDD