Token-Ring Adapter Installation and Support Guide

Relocating a TRSA
Token-Ring Adapter Installation and Support Guide—426955-001
4-24
Resume Operations
Resume Operations
The following sections describe starting the relocated TRSA:
Complete the TRSA Configuration Form
Complete a new configuration form for the relocated TRSA. Figure 4-9 on page 4-25
shows an example of a completed Token-Ring ServerNet Adapter (TRSA)
Configuration Form.
Identify the following information for the relocated TRSA:
•
The name you want to use to identify the adapter; for example, E0153 for a Token-
Ring adapter in slot 53 of the first system enclosure.
•
The location of the adapter within the system cabinet (group, module, and slot).
•
The processors that have access to the SACs on the adapter.
Obtain the form from Appendix A, TRSA Configuration Form
, and enter the following
information:
•
The name of the system in the System Name field.
•
The group number for this enclosure in the Group Number field.
•
The slot number of this TRSA in the Slot Number field. TRSAs can be installed
in slots 51, 52, 53 and 54 of an I/O enclosure (expansion) but only 53 and 54 of
a processor enclosure.
•
Note that because there is exactly one module in a system or I/O enclosure, the
module number, 1, is already indicated on the form.
•
Enter the remaining information needed to install the TRSA:
•
The IP address.
•
The adapter name (See Manufacturing Naming Conventions on page 1-8).
•
The numbers of the processors that will have access to the SAC in the SAC
Access List field. The first processor listed is the preferred processor.
•
The PIF name associated with the SAC in the PIF Name field.
•
The LIF name associated with the PIF in the LIF Name field.
•
When you have completed this form, enter today’s date in the Date field.
Table 4-3. Resuming Operations Checklist
Step Description
1.
Complete the TRSA Configuration Form
2.
Add the TRSA Using SCF