TPDC Manual (G06.24+)

Cross-Reference of Enform Queries to Data Files
Tandem Performance Data Collector (TPDC) Manual—526357-001
B-2
!----------------------------------------------------------------------------!
! For each such line (unless, of course, it begins with an !
! exclamation mark), TBUILD adds a "?Execute R<report>" line to !
! the command file it is building if, and only if: !
! !
! a. The ENFORM-compiled query file R<report> exists and !
! has a file code of 888, and !
! !
! b. Each <data-file> in the list exists, with a non-zero EOF; !
! <data-file>s enclosed in parentheses are NOT checked, !
! however, since the parentheses indicate that the file !
! is the right side of an ENFORM LINK OPTIONAL. !
! !
! For information, lower-case <data-file> names indicate !
! standard MEASURE structured files; upper-case <data-file> !
! names indicate files built by the (SPAM) TGATHER routine. !
! !
! Observe, therefore, that <report> is the "logical" report name, !
! as shown in the lower right-hand corner of each report page; !
! the actual ENFORM-compiled query file name is always R<report>. !
! !
! By following the above procedures, you can customize your own set of !
! charts and/or reports that are meaningful for the MEASURE data from !
! the system you are analyzing. The default <report-set>s defined here !
! are: !
! !
! CHARTS - 80-column pseudo-graphic charts and overview tables !
! !
! REPORTS - 132-column detailed reports !
! !
! Some charts and reports are "commented out" because they are either !
! of relatively little value, are very voluminous, or require session !
! PARAMeter values (e.g. PROGRAM or FILE) to be set, since they report !
! on just a few selected entities. They are included in this file for !
! completeness. !
!----------------------------------------------------------------------------!