TR3271 Management Programming Manual

MANAGEMENT PROGRAMMING FOR TR3271
Commands
COMMANDS
Table 2-1 lists and briefly describes the commands that a
management application can send to the TR3271 subsystem using
the control-and-inquiry interface. For detailed descriptions of
these commands as they relate to the TR3271 subsystem, refer to
Section 6, "Commands and Responses." For a description of these
commands as they relate to all data-communications subsystems,
or for information about using SPI messages to communicate
with data-communications subsystems in general, refer to the
Communications Management Programming Manual .
Table 2-1. TR3271 Programmatic Commands (Page 1 of 2)
COMMAND DESCRIPTION
ABORT Terminates the operation of a line and
subdevices immediately.
ADD Adds a subdevice to the TR3271
subsystem.
ALTER Changes the values of the attributes of a
line or subdevice.
CONNECT Establishes a link between a TR3271 subdevice
and an AM3270 subdevice when in
pass-through mode.
DELETE Removes subdevices from the TR3271 subsystem.
DISCONNECT Breaks the link between a TR3271 subdevice and
an AM3270 subdevice when in pass-through
mode.
GETVERSION Returns the version level and version banner
for the TR3271 subsystem.
INFO Returns the current values of the attributes
of lines and subdevices.
2-4