TRANSFER Administration Guide Volume 2 Messages Manual

TRANSFER Errors (4000-6999)
2–154 40592 Tandem Computers Incorporated
6127
Problem getting statistics configuration. See your system manager.
Cause. A bad date/time was detected, either because the current system date/time is
wrong or because it was previously set wrong while statistics were being collected.
Effect. The requested function is not performed.
Recovery. Report this error to your system manager.
The system manager should immediately stop TRANSFER and examine the system
date/time. If it is incorrect, it should be reset. The PARAM called TIMEWASRESET
should be set to Y. Then XCOOL should be run.
If the time is correct, you should set the PARAM called TIMEWASRESET to N, and
then run XCOOL.
6131
Problem accessing the next statistics configuration.
Cause. A problem occurred while the next configuration for statistics was accessed.
Effect. The configuration is not accessed.
Recovery. Report the error and the error number displayed at the right end of the
advice line to the system manager or the Tandem Online Support Center.
6132
Problem accessing the current statistics configuration.
Cause. A problem occurred while the current configuration for statistics was accessed.
Effect. The configuration is not accessed.
Recovery. Report the error and the error number displayed at the right end of the
advice line to the system manager or the Tandem Online Support Center.
6133
Invalid request date.
Cause. You specified an invalid request date.
Effect. The requested function is not performed.
Recovery. Check that the value given for the request date first specifies a valid year,
month, and day followed by a valid hour and minute specification. Note that the time
uses a 24-hour clock format, so values from 00:00 to 23:59 are valid.
Then try the operation again.