TRANSFER Installation and Management Guide

System Installation Procedures
068837, Update 1 to 013198 Tandem Computers Incorporated 6–37
8. Purge GTRINIT, GTRFUP, and GTRLOAD to reduce the possibility of accidentally
repeating OBEY GTRINIT and destroying data files.
9. Enter this command:
4> RUN CDMLDEF /OUT $S.#MLDEF/ [$ vol .] cnfg-subvol
to define PS MAIL 6530. (CDMLDEF resides on the TRANSFER user-DSV.)
10. Enter this command:
5> RUN CDIMDEF /OUT $S.#IMDEF/ [$ vol .] cnfg-subvol
to define PS MAIL 3270. (CDIMDEF resides on the TRANSFER user-DSV.)
11. Enter this command:
6> RUN CDCMDEF /OUT $S.#CMDEF/ [$ vol .] cnfg-subvol
to define PS MAIL TTY. (CDCMDEF resides on the TRANSFER user-DSV.)
12. Enter this command:
7> RUN CDX4DEF /OUT $S.#X4DEF/ [$ vol .] cnfg-subvol INITIAL
to define the X400 gateway. (CDX4DEF resides on the TRANSFER user-DSV.)
13. Enter this command:
8> OBEY GX4INIT
to initialize the X400 gateway. (Do this only for the first installation or for
reinitialization, not for redefinition; this purges any existing X400 gateway
database files.)
14. Purge GX4INIT, GX4FUP, and GX4LOAD to reduce the possibility of accidentally
repeating OBEY GX4INIT and destroying data files.
15. Prepare customizing files (described in Section 7).
16. Generate a TMF online dump of the audited files after initializing the files and
before starting TRANSFER.
17. Enter this command:
9> RUN XCNFG
to configure the PATHWAY entities for the TRANSFER system, cold start, and
stop the TRANSFER PATHWAY system. (XCNFG resides on your configuration
subvolume.)
TRANSFER Initial Installation Summary