TRANSFER Installation and Management Guide

General PARAM Specifications
Customizing a TRANSFER System
7–6 068837, Update 1 to 013198 Tandem Computers Incorporated
Table 7-1. General PARAM Specifications (Page 2 of 2)
Parameter/Default Definition
DEBUGLOGFORMAT
Default = FALSE
Must be TRUE or FALSE
Format for logging to the debug log file.
Set this parameter to TRUE for logging in hexadecimal ASCII format
or to FALSE for logging in binary format.
DEBUGLOGLEVEL
Default = 3
Severity of reply-code error necessary for debug logging to occur. If
the reply code is equal to or greater than the specified value, logging
occurs. Specifying a value of zero causes all messages and replies to
be logged. A value of 4 or greater causes nothing to be logged.
DEBUGLOGRECSPEROPEN
Default = 20
Number of IPCs written to the debug log file after which the file is
closed and reopened.