TRANSFER Installation and Management Guide

Definition Program Messages
Error Messages
B–16 13198 Tandem Computers Incorporated
WARNING: The following files have been created:
file-list
Cause. A fatal error occurred while EDIT was processing the files generated by the
definition program. The files in the list were created before the fatal error occurred;
these files are incomplete, however, and you should not try to use them to install the
component.
Effect. This is a warning message.
Recovery. Purge any files that were created, rectify the problem, and run the definition
program again.
A copy of these files should accompany any documentation sent to Tandem.
WARNING: Relocating obsolete installation files:
Old file-name moved to file-name
Old file-name moved to file-name
Old file-name moved to file-name . . .
Cause. If any of the files generated by a definition program already exist on the
configuration subvolume, the files are resecured and then moved to another
subvolume. The PATHCTL file is also moved, because running a definition program
makes it invalid for the newly generated TRANSFER configuration.
Effect. This is a warning message.
Recovery. Procedures for moving existing files are described in Section 6
You can purge the old files if they are no longer useful.
WARNING: TRTRecvServs/TRTFrontTerms = 0; delivery from other
nodes disabled
Cause. Your TRANSFER system cannot receive packages from TRANSFER systems on
other nodes when the number of TRECV servers and TFRONT receiver front ends is 0.
This situation is appropriate if your TRANSFER system runs on only one node.
Effect. This is a warning message.
Recovery. If your system runs on more than one node, you must set both values greater
than zero and run the definition programs again.