TRANSFER Installation and Management Guide

Gateway Startup Messages
Error Messages
B–28 13198 Tandem Computers Incorporated
C2006 Couldn’t start a session, error nnnn
Cause. The indicated error occurred when this server attempted to start a TRANSEFER
session for the Gateway depot _X400_.
Effect. The server stops after generating this message.
Recovery. Determine why TRANSFER was unable to start the session; make sure that
TMF is running.
C2007 Couldn’t open console $0 (required by X.400)
Cause. This server was unable to open file $0.
Effect. The server stops after generating this message.
Recovery. You should not get this error; if it occurs, call your system analyst.
C2009 X.400’s country did not match TRANSFER’s; s1 vs. s2
Cause. The OSI/MHS definition of the TRANSFER gateway did not match the
definition defined in the DEFINEX4 file. The string denoted by s1 is what the MHS
expects the country name to be, and the string s2 is what was defined for the
TRANSFER gateway.
Effect. The server stops after generating this message.
Recovery. Correct either definition to match the other. If you change the MHS
definition, be sure to restart the MR group. Then restart the X400-EXPORTER and
X400-IMPORTER servers.
C2010 X.400’s ADMD did not match TRANSFER’s; s1 vs. s2
Cause. The OSI/MHS definition of the TRANSFER gateway did not match the
definition defined in the DEFINEX4 file. The string denoted by s1 is what the MHS
expects the ADMD to be, and the string s2 is what was defined for the TRANSFER
gateway.
Effect. The server stops after generating this message.
Recovery. Correct either definition to match the other. If you change the MHS
definition, be sure to restart the MR group. Then restart the X400-EXPORTER and
X400-IMPORTER servers.