TS/MP Management Programming Manual (G06.24+, H06.03+)

ZPWY-MAP- Definitions
NonStop TS/MP Management Programming Manual—540082-001
7-26
ZPWY-MAP-DEF-SCPROCESS
When ZCPUPAIR is used with ZPWY-MAP-DEF-SCPROCESS, the PATHMON
process uses the CPUs specified for the server process. The CPUs specified for
the server process do not need to match the CPUs specified for the server class in
ZPWY-MAP-DEF-SC.
If you do not assign a value to the ZCPUPAIR fields, the system assigns the same
value designated in the ZCPUPAIR field in ZPWY-DDL-DEF-SC.
Entering values for ZPRIMARY and ZBACKUP is optional in multiprocessor
environments; the system assigns CPUs if you do not designate any.
ZDEBUG
determines wether the server enters debug mode on startup. The valid values are:
If you do not assign a value to this field, the default is the value specified for the
same field in ZPWY-DDL-DEF-SC.
ZGUARDIANSWAP
specifies the Guardian name of the disk volume for the server swap file formerly
used by the operating system for memory swaps of the server data area. Allocation
of this swap file is handled by the Kernel-Managed Swap Facility (KMSF) on behalf
of the PATHMON process, and the value for this attribute is not used. However, if
you specify a value for this parameter, it must represent an existing device, or an
error occurs.
ZHOMETERM
is the name of the home terminal for the server processes in this server class.
The node name can be either a specific node name or \*, a generic name
representing the node on which the PATHMON process is currently running. If you
do not specify a node name, the default node for the file-name expansion is
determined by the value you specify for the ZNODEINDEPENDENT field of the
START PATHWAY command.
ZPWY-VAL-
OFF
Directs the server process not to enter debug mode.
ZPWY-VAL-ON Directs the server process to enter debug mode. If the
PATHMON process was started with INSPECT ON or the
server program was compiled or bound with the Inspect
process defined, the servers enter Inspect mode for
debugging.
For more information about Inspect mode, see the Inspect
Manual. For information regarding errors that can occur when
a server process is in debug mode, see the TS/MP Pathsend
and Server Programming Manual.