TS/MP Management Programming Manual (G06.24+, H06.03+)

Pathway Subsystem Control Commands

NonStop TS/MP Management Programming Manual—540082-001

8-2

CONTROL PM

Use the CONTROL PM command to change specific attributes of the PATHMON

process while it is running and to record the changes in the PATHMON configuration

file.

Continuation

You cannot use continuation with this command.

Command Syntax

For tokens that may be present in the command and response buffers but are not

listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see

Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-

Definitions.

Log File Error Recovery

While your Pathway subsystem is running, the PATHMON process and the

Pathway/iTS TCPs report error and status information to a log file. Using the fields

associated with ZLOG1INFO and ZLOG2INFO, you can direct the PATHMON process

to report errors only or errors and changes in object status as well. You can direct the

PATHMON process to log information to only one file or to copy the information to two

files. Also you can request that this error and status information be formatted either as

text or as event messages. For more information about TCPs, see the Pathway/iTS

System Management Manual.

If an error occurs while error information, status information, or both are being written

to a log file, the PATHMON process:

1. Closes the log file specified with the ZFILE field.

2. Opens $0 (a collector process provided with TS/MP).

Command

ZPWY-CMD-CONTROL

Object Type

ZPWY-OBJ-PM

Tokens in Command Buffer

ZPWY-MAP-PAR-CONTROL-PM token-type ZPWY-DDL-PAR-CONTROL-PM.