TS/MP Management Programming Manual (G06.24+, H06.03+)

Pathway Subsystem Control Commands
NonStop TS/MP Management Programming Manual—540082-001
8-16
STOP PATHWAY
Command Syntax
For tokens that may be present in the command and response buffers but are not
listed, see Unlisted Tokens on page 3-29. For descriptions of tokens and fields, see
Section 4, SPI and EMS Standard Definitions through Section 7, ZPWY-MAP-
Definitions.
Tokens in Response Buffer
For STOP PATHWAY, common error values for ZSPI-TKN RETCODE are:
1004 (ZPWY-ERR-PM-ALREADYSTOPPED)
indicates the Pathway subsystem is already stopped.
1045 (ZPWY-ERR-PM-STATEMISMATCH)
indicates the Pathway subsystem is not in the appropriate state to allow the
PATHMON process to execute the STOP request.
For descriptions of all error token values and their associated error lists, see
Section 10, Event Management.
Considerations
•
To implement the equivalent of the PATHCOM SHUTDOWN command, issue
these commands in this order:
1. Issue a STOP TERM command for each Pathway/iTS TERM, specifying
continuation.
2. Issue a STOP TCP command for each Pathway/iTS TCP, specifying
continuation.
3. Issue a STOP PATHWAY command.
For more information about continuation, see Specifying Continuation on
page 3-17. For more information about Pathway/iTS commands, see the
Pathway/iTS Management Programming Manual.
Command
ZPWY-CMD-STOP
Object Type
ZPWY-OBJ-PATHWAY
Tokens in Response Buffer
ZSPI-TKN-RETCODE token-type ZSPI-TYP-INT.